JACKING & HOISTING :: 1993 :: Jeep Cherokee (XJ) :: Jeep Cherokee

Online Manual Jeep > Jeep Cherokee > Jeep Cherokee (XJ) > 1993 > JACKING & HOISTING

�

1993 Jeep Cherokee

1993 WHEEL ALIGNMENT

Chrysler Corp. Jacking & Hoisting

Jeep; Cherokee, Grand Cherokee, Grand Wagoneer, Wrangler

JACKING & HOISTING

FLOOR JACK

Vehicle may be raised by positioning jack under front or rear frame rails. See Fig. 1.

NOTE:

Use sub-frame rail lift points to hoist vehicle. Never raise vehicle with jack under axle tubes, body side sills, steering linkage components, drive shafts,

engine/transmission oil pans, fuel tank or front suspension arms.

Fig. 1: Identifying Front & Rear Lifting Points Courtesy of Chrysler Corp.

EMERGENCY JACKING

Except Wrangler

Park vehicle on a firm, level surface. Block tire diagonally opposite tire being changed. Place automatic transmission in Park, manual transmission in Reverse. Set parking brake. Position emergency jack under front or rear axle housing. Raise vehicle.

Wrangler

HOIST

Vehicle may be raised on single or twin-post swiveling arm, or ramp-type drive hoists. If using swiveling arm hoist, ensure lifting pads are positioned evenly at sub-frame lift points. See Fig. 2 and Fig. 3. All hoists should be equipped with proper adapters to support vehicle at frame rails only.

50111732

Fig. 2: Hoist Lift Point Locations (Cherokee) Courtesy of Chrysler Corp.

Fig. 3: Identifying Hoist Lifting Points (Grand Cherokee) Courtesy of Chrysler Corp.